Lines Matching +full:higher +full:- +full:than +full:- +full:threshold

19 Example: If your kernel is called linux-2.6.9, type the following line
22  linux-2.6.9 floppy=thinkpad
25 of linux-2.6.9::
31  linux-2.6.9 floppy=daring floppy=two_fdc
96 	and is thus harder to find, whereas non-dma buffers may be
101 	threshold to 10 or lower, in order to limit the number of data
104 	If you have a FIFO-able FDC, the floppy driver automatically
105 	falls back on non DMA mode if no DMA-able memory can be found.
120  floppy=<threshold>,fifo_depth
121 	Sets the FIFO threshold. This is mostly relevant in DMA
122 	mode. If this is higher, the floppy driver tolerates more
126 	processor). The benefit of a lower threshold is less
129 	To tune the fifo threshold, switch on over/underrun messages
130 	using 'floppycontrol --messages'. Then access a floppy
131 	disk. If you get a huge amount of "Over/Underrun - retrying"
132 	messages, then the fifo threshold is too low. Try with a
133 	higher value, until you only get an occasional Over/Underrun.
137 	that you need to do 'floppycontrol --messages' every time you
138 	re-insert the module.
140 	Usually, tuning the fifo threshold should not be needed, as
145 	you have more than two floppy drives (only two can be
147 	non-standard CMOS types. The CMOS types are:
207 	   PS/2 floppies have much slower step rates than regular floppies.
231  ftp://metalab.unc.edu/pub/Linux/utils/disk-management/
250 10-30-2004 :
254 6-3-2000 :