Lines Matching +full:read +full:- +full:to +full:- +full:read

5 		It is a read only file. It contains status of the watchdog
6 		device at boot. It is equivalent to WDIOC_GETBOOTSTATUS of
13 		It is a read only file. It contains options of watchdog device.
19 		It is a read only file. It contains firmware version of
26 		It is a read only file. It contains identity string of
33 		It is a read/write file. While reading, it gives '1'
35 		it gives '0'. Writing a '1' to the file enables the
45 		It is a read only file. It gives active/inactive status of
52 		It is a read only file. It contains watchdog device's
53 		internal status bits. It is equivalent to WDIOC_GETSTATUS
60 		It is a read only file. It contains value of time left for
61 		reset generation. It is equivalent to WDIOC_GETTIMELEFT of
68 		It is a read only file. It is read to know about current
75 		It is a read only file. It specifies the time in seconds before
83 		It is a read only file. It shows the pretimeout governors
90 		It is a read/write file. When read, the currently assigned
99 		It is a read/write file. This attribute exists only if the
100 		system has booted from the alternate flash chip due to
102 		alternate boot function was enabled with 'aspeed,alt-boot'
109 				a way to get access to the primary SPI flash
113 				a way to restore the normal address mapping
114 				from (CS0->CS1, CS1->CS0) to (CS0->CS0,
115 				CS1->CS1).
118 		resets to the initial state the chip select line mapping. When
121 		For alternate boot mode (booted from CS1 due to wdt2
126 		When read, the current status of the boot code selection is
127 		shown. When written with any non-zero value, it clears