Lines Matching full:battery

37 		Valid values: "Battery", "UPS", "Mains", "USB", "Wireless"
39 **Battery and USB properties**
45 		Battery:
47 		  Reports an average IBAT current reading for the battery, over
68 		Battery:
70 		  Reports the maximum IBAT current allowed into the battery.
84 		Battery:
87 		  battery. This value is not averaged/smoothed.
108 		Battery:
110 		  Reports the current TBAT battery temperature reading.
126 		Battery:
151 		Battery:
175 		Battery:
177 		  Reports the maximum allowed TBAT battery temperature for
192 		Battery:
194 		  Reports the minimum allowed TBAT battery temperature for
209 		Battery:
212 		  battery, during charging.
226 		Battery:
229 		  battery, during discharging.
243 		Battery:
246 		  battery. This value is not averaged/smoothed.
261 **Battery Properties**
267 		Fine grain representation of battery capacity.
277 		Maximum battery capacity trip-wire value where the supply will
279 		battery discharging scenario where user-space needs to know the
280 		battery has dropped to an upper level so it can take
281 		appropriate action (e.g. warning user that battery level is
292 		Minimum battery capacity trip-wire value where the supply will
294 		battery discharging scenario where user-space needs to know the
295 		battery has dropped to a lower level so it can take
296 		appropriate action (e.g. warning user that battery level is
307 		Battery capacity measurement becomes unreliable without
323 		Coarse representation of battery capacity.
336 		throttling for thermal cooling or improving battery health.
356 		Represents a battery percentage level, below which charging will
366 		Represents a battery percentage level, above which charging will
380 		Select the charging algorithm to use for a battery.
383 			Fully charge the battery at a moderate rate.
385 			Quickly charge the battery using fast-charge
386 			technology. This is typically harder on the battery
391 			battery life with this mode. Vendor tooling may
394 			Automatically optimize battery charge rate based
399 			can use this to drastically extend battery life.
402 			prolong the battery health.
419 		when the battery is considered full and charging should end.
429 		Reports the health of the battery or battery side of charger
439 			      "Cool", "Hot", "No battery"
446 		for a battery charge cycle.
456 		Reports whether a battery is present or not in the system. If the
457 		property does not exist, the battery is considered to be present.
472 		Represents the charging status of the battery. Normally this
474 		used to enable/disable charging to the battery.
501 		Describes the battery technology supported by the supply.
514 		Reports an average VBAT voltage reading for the battery, over a
527 		battery has undergone.
612 		as battery charger chips, this indicates the type of
624 What:		/sys/class/power/ds2760-battery.*/charge_now
630 		coloumb counter value inside the battery monitor chip. This
632 		A userspace daemon can monitor the battery charging logic
636 What:		/sys/class/power/ds2760-battery.*/charge_full
642 		battery 'full level'. As batteries age, this value has to be
757 		devices. If enabled and the input is removed, the internal battery FET
759 		than 1uA. Note that on some devices/systems this disconnects the battery