Lines Matching full:attribute

12 		Unless otherwise specified in an attribute description all attributes are optional
16 		    A file that can be read to obtain the type of attribute.
17 		    This attribute is mandatory.
30 		All attribute types support the following values:
39 				This attribute is mandatory.
73 					increments of current_value this attribute accepts.
91 				A file that can be read to obtain attribute-level
92 				dependency rule. It says an attribute X will become read-only or
93 				suppressed, if/if-not attribute Y is configured.
97 				    [ReadOnlyIf:<attribute>=<value>]
98 				    [ReadOnlyIfNot:<attribute>=<value>]
99 				    [SuppressIf:<attribute>=<value>]
100 				    [SuppressIfNot:<attribute>=<value>]
108 				attribute is not "SelectDays" and its value will not be effective
116 					attribute's current value will be forcefully changed based
121 					    <value>[ForceIf:<attribute>=<value>]
122 					    <value>[ForceIfNot:<attribute>=<value>]
147 					the priority order for the particular attribute.
172 					This attribute is mandatory.
176 					This attribute is mandatory.
195 					The means of authentication.  This attribute is mandatory.
211 					This attribute is mandatory when mechanism == "password".
262 					This attribute defaults to 'user' level
267 					This attribute defaults to device 1.
273 					The user writes to the attribute(s) with a BASE64 encoded string obtained
298 							echo Enable > attribute/PasswordBeep/current_value
308 					Read only attribute used to display the MD5, SHA1 and SHA256 thumbprints
312 					Write only attribute used to switch from certificate based authentication
325 					This role is specific to Secure Platform Management (SPM) attribute.
336 		A read-only attribute reads 1 if a reboot is necessary to apply
337 		pending BIOS attribute changes. Also, an uevent_KOBJ_CHANGE is
343 				attribute changes applied
351 		2.	Before setting any attribute, check if it has any modifiers
353 			attribute.
365 		This attribute can be used to reset the BIOS Configuration.
383 		Note that any changes to this attribute requires a reboot
391 		On Lenovo platforms there is a limitation in the number of times an attribute can be
394 		A solution for this is instead of the attribute being saved after every modification,
398 		Read the attribute to check what save mode is enabled (single or bulk).
403 		Write the attribute with 'bulk' to enable bulk save mode.
404 		Write the attribute with 'single' to enable saving, after every attribute set.
421 		This write only attribute can be used to send debug commands to the BIOS.
425 		Note that any changes to this attribute requires a reboot for changes to take effect.