Lines Matching full:signal

94 			The output signal is initially low, and will remain low
95 			until the counter reaches zero. The output signal then
100 			The output signal is initially high. The output signal
101 			will go low by a trigger input signal, and will remain
105 			value and setting the output signal low, thus starting
109 			The output signal is initially high. When the counter
110 			has decremented to 1, the output signal goes low for one
111 			clock pulse. The output signal then goes high again, the
116 			The output signal is initially high.
120 			expires, the output signal changes value and the
127 			the count expires, the output signal goes low and the
135 			The output signal is initially high. When the count
141 			The output signal is initially high. Counting is started
142 			by a trigger input signal. When the count expires, the
143 			output signal will go low for one clock pulse and then
208 			Rising edges on signal A updates the respective count.
209 			The input level of signal B determines direction.
213 			signal A updates the respective count; if the direction
214 			is backward, falling edges on quadrature pair signal A
220 			signal B updates the respective count; if the direction
221 			is backward, falling edges on quadrature pair signal B
226 			Any state transition on quadrature pair signal A updates
231 			Any state transition on quadrature pair signal B updates
277 		Action mode of Count Y for Signal Z. This attribute indicates
278 		the condition of Signal Z that triggers the count function
283 			Signal does not trigger the count function. In
284 			Pulse-Direction count function mode, this Signal is
374 		for the respective channel of Signal Y. Valid attribute values
383 		respective channel of Signal Y is enabled. Valid attribute
390 		Filter clock factor for input Signal Y. This prescaler value
397 		Active level of index input Signal Y; irrelevant in
405 		Discrete set of available values for the respective Signal Y
412 		Active level of Signal Y. The following polarity values are
416 			Signal high state considered active level (rising edge).
419 			Signal low state considered active level (falling edge).
426 		Signal Y. If possible, this should match the name of the
427 		respective signal as it appears in the device datasheet.
429 What:		/sys/bus/counter/devices/counterX/signalY/signal
433 		Signal level state of Signal Y. The following signal level
446 		Configure the counter associated with Signal Y for
468 		Read-only attribute that indicates the signal Y frequency, in Hz.